Land Units in Gujarat Explained: Vaar, Gaj, Square Feet, Bigha and Acre

Vaar = gaj =

1 square yard

1 square yard

9 square feet

1 acre

4,840 sq yd = 43,560 sq ft

1 acre

about 4,047 sq metres

Bigha (Gujarat)

commonly ~2,500 sq yd, not standardised

If you are comparing plot prices in Dholera, the first hurdle is units. One seller quotes per vaar, another per square foot, a third per bigha, and a fourth per acre. To compare them fairly you have to convert everything to a single unit.

This guide sets out the safe, durable conversions used in Gujarat, explains which unit is used where, and flags the one unit, the bigha, that is not standardised and must always be confirmed locally.

Dholerapedia is an independent, neutral reference. It does not sell plots or quote plot prices. The conversions here are arithmetic constants that do not change. Where a unit varies by region, we say so and tell you to confirm the local figure in writing before you rely on it.

There are two families of units in play. The first is the square-based family used for plots: vaar, gaj, square yard, square foot and square metre. The second is the larger land-parcel family used for farmland and big tracts: bigha and acre. Developed plots in Dholera are usually quoted per square yard or per square foot, while raw or agricultural land is more often quoted per bigha or acre.

These figures are fixed arithmetic and safe to state as fact, with the single exception of the bigha, which is flagged. Use this table to bring every quote onto one common unit before you compare rupee rates.

To run these numbers on a specific plot without doing the arithmetic by hand, use the converter in Dholerapedia tools. It applies the same fixed constants above.

The square-based units are the easy part because they are all fixed. Start from the square yard, since vaar and gaj are just other names for it. One square yard is 9 square feet, so a 100 square yard plot is 900 square feet.

Going up, one acre is 4,840 square yards, and multiplying by 9 gives 43,560 square feet per acre. In metric terms, one acre is about 4,047 square metres, and one square yard is about 0.836 square metre.

The chart shows why unit choice matters so much. A plot quoted as "one bigha" at a common Gujarat value of about 2,500 square yards is roughly 22,500 square feet, a little over half an acre, but because the bigha is not standardised, that same word could describe a different area elsewhere. Never take the word "bigha" at face value.

The bigha is the one unit that trips up buyers. It is a traditional measure with no single national definition, and its size differs across states and even across districts within a state. In Gujarat it is commonly treated as about 2,500 square yards, which is roughly half an acre, but this is a convention, not a fixed standard.

Two sellers both quoting "per bigha" may be using different underlying areas, which distorts any price comparison.

Confirm the bigha: the bigha is not standardised and varies by region. Before you compare or pay on a per-bigha quote in Dholera, get the exact square-yard or square-foot area of the specific plot in writing, and convert everything to one unit yourself.

Knowing the convention helps you read a quote correctly. Developed and plotted land in Dholera is usually priced per square yard or per square foot, which is why those two units dominate brokerage listings for organised plots. Raw and agricultural land, and large tracts, are more often quoted per bigha or per acre.

Official master-plan and Town Planning documents use square kilometres and hectares for zones and schemes. When you cross between these worlds, convert to square feet or square yards, the units most buyers can picture.

None of these conversions tell you whether a rate is fair or a plot is sound. For that, the location and paperwork matter far more than the arithmetic. See how to think about areas in Dholera and the verification steps in how to buy a plot in Dholera. For the wider land-price context, see Dholera plot prices.

Suppose you are shown three quotes: plot A at a rate per square yard, plot B at a rate per square foot, and plot C at a rate per bigha. To compare them, convert all three to a per-square-foot rate. For plot A, divide the per-square-yard rate by 9.

For plot B, use it as is. For plot C, first pin down the exact square-yard area of that bigha in writing, convert to square feet by multiplying by 9, then divide the total price by that area. Only once all three are per square foot can you compare like with like.

This is a thinking tool, not a valuation: always verify the actual quoted rate and the plot's paperwork.